Y reference lines and "Operate on Y"

raswaim · Post by **raswaim** » Sat Jun 30, 2007 7:38 pm

When using operate on Y from the edit menu (v2.1.1.9), I've found that all of the reference lines are also getting operated on even when I only select one curve as the target. Haven't noticed this before but I don't use this feature regularly enough to say how long it's been doing this...

Post by **DPlotAdmin** » Mon Jul 02, 2007 8:44 am

Richard,
Thanks, that's a mistake. What it should be doing (and will in the next release) is applying that transform to Y reference lines only if all curves are being operated on.